The Real Challenges of Multi-Stand Cold Rolling Mills

The real challenge of multi-stand cold rolling mills is not merely “rolling thin material”. Instead, it lies in the simultaneous control of thickness, flatness, surface quality and rolling stability under combined conditions of thin gauge, high hardness and high speed.

  1. Flatness Control Is the Top Challenge Edge wave, center wave, quarter wave, high-order wave, edge drop and transverse thickness difference interact with one another. Bending, shifting, tilting, sectional cooling and roll contour must be adjusted in coordination — numerous control means with strong coupling effects. For complex roll systems such as 18-high and 20-high mills, the formation mechanism of defects is more complicated, and traditional empirical models are no longer sufficient.
  2. Stable Thickness Accuracy Is Difficult to Maintain The target is not just qualified average thickness, but consistent thickness across head, tail, edge and center of the strip. High-strength steel and silicon steel feature rapid work hardening. Any fluctuation in rolling force will cause synchronous changes in mill stretch, roll gap deformation and edge drop. The AGC system must manage rolling force, tension, roll gap and thermal crown simultaneously while suppressing lag and overshoot.
  3. Heat Dissipation and Lubrication Are Constrained by Limited Space 18-high and 20-high mills have compact roll arrangements and small opening strokes, with nozzles located far from the roll gap. Coolant and lubricant fail to reach the rolling zone effectively, leading to localized temperature rise. This triggers flatness fluctuation, roll sticking, degraded surface quality and limits maximum rolling speed. After optimized spray structures were adopted, the top rolling speed reaches approximately 1000 m/min.
  4. Strip Breakage Incidents Are Difficult to Handle Thin gauge strip, high-strength steel and silicon steel have low cold-work ductility. Edge cracking, weld fracture and breakage due to tension loss occur frequently. 20-high mills offer high rigidity at the cost of small opening. Once broken strip wraps around rolls, troubleshooting takes substantial time and drags down productivity.
  5. Extremely Strict Requirements for Roll Management Work rolls need high hardness, wear resistance and fatigue resistance, with zero surface cracks, indentations or spiral marks. In stainless steel production on 20-high mills, work rolls are often replaced more than twice per coil, with grinding accuracy required up to 5 μm. Simply put, roll surface condition directly determines strip surface quality; poor roll management leads to higher scrap rates.
  6. High Barriers for Equipment Fabrication and Assembly The monoblock housing, back-up bearings, roll positioning, hydraulic screwdown, AGC and flatness closed-loop system all demand high-precision matching. Minor roll misalignment, bearing failure or sensor drift will immediately induce strip waves or thickness deviations on thin gauge products.
  7. Difficult Implementation of Process Models Intelligent control and digital twin are widely discussed, yet pure black-box models carry risks in industrial closed-loop control: data drift, scarce abnormal samples and poor interpretability. The reliable solution integrates mechanism principles, data analysis and on-line control, which also meets millisecond-level real-time response requirements.

In short: The core difficulty of multi-high cold rolling lies in sustaining system stability under thin-gauge and high-hardness rolling conditions.

Similar Posts